HONDA 2007 CR-V - Owner's Manual - Manual (Page 206)

Handle a disc by its edges; never
touch either surface. Do not place
stabilizer rings or labels on the disc.
These, along with contamination
from fingerprints, liquids, and felt-tip
pens, can cause the disc to not play
properly, or possibly jam in the drive.
When using CD-R or CD-RW discs,
use only high quality discs labeled
for audio use.
When recording a CD-R or
CD-RW, the recording must be
closed for it to be used by the
system.
Play only standard round discs.
Odd-shaped discs may jam in the
drive or cause other problems.
Handle your discs properly to
prevent damage and skipping.
When a disc is not being played,
store it in its case to protect it from
dust and other contamination. To
prevent warpage, keep discs out of
direct sunlight and extreme heat.
To clean a disc, use a clean soft cloth.
Wipe across the disc from the center
to the outside edge.
A new disc may be rough on the
inner and outer edges. The small
plastic pieces causing this roughness
can flake off and fall on the
recording surface of the disc,
causing skipping or other problems.
Remove these pieces by rubbing the
inner and outer edges with the side
of a pencil or pen.
Never try to insert foreign objects in
the system or the magazine.
General Inf ormation Protecting Discs
Protecting Your Discs
202
Do not use discs with adhesive labels.
The label can curl up and cause the
disc to jam in the unit.
Main Menu Table of Contents