HONDA 2014 Ridgeline - Owner's Manual - Manual (Page 99)

OFF
INT: Intermittent
INT TIME ring
LO: Low speed
HI: High speed
MIST
Windshield washers
Turn signal
High beams
Flash high beams
The multi-control lever has many
functions, including windshield
wipers and washers, turn signals,
headlight high beams, and headlight
high beam flashing.
To select a position, turn the rotary
switch, push the button on the end of
the lever, or push the lever up, down,
forward, or backward.
The wipers are not activated.
The wipers run at low speed.
The wipers run at high speed.
The length of the wiper
interval is varied automatically
according to the vehicle’s speed.
Vary the delay by turning the INT
TIME ring. If you turn it to the
shortest delay, the wipers change
to low speed when the vehicle
speed exceeds 12 mph (20 km/h).
The wipers run at high speed
until you release the lever.
Push the
button on the end of the multi-
control lever. The washers spray
until you release the button. The
wipers run at low speed, then
complete one more sweep after
you release the button.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
OFF:
LO
HI
INT:
MIST:
Windshield Washer:
Multi-Control Lever
94
12/08/09 16:11:40 31SJC670_101
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
2014 Ridgeline