HONDA 2015 Odyssey - Owner's Guide (Revised 09/24/2014) - Manual (Page 65)

122 | | 123
MAINTENANCE MAINTENANCE
U.S. Models
Maintenance, replacement, or repair of emissions control devices and systems
may be done by any automotive repair establishment or individuals using parts
that are certifi ed to EPA standards.
According to state and federal regulations, failure to perform maintenance on the
maintenance main items marked with # will not void your emissions warranties.
However, all maintenance services should be performed in accordance with the
intervals indicated by the multi-information display.
Maintenance Minder Service Codes
These codes indicate what services are due on your vehicle.
*1: If a message SERVICE does not appear more than 12 months after the display is reset,
change the engine oil every year.
# : See information on maintenance and emissions warranty.
CODE Maintenance Main Items
A Replace engine oil *1
B Replace engine oil *1 and oil filter
Inspect front and rear brakes
Check parking brake adjustment
Inspect tie rod ends, steering gearbox, boots, and
drain plug
Inspect suspension components
Inspect driveshaft boots
Inspect brake hoses and lines (including ABS/VSA)
Inspect all fluid levels and condition of fluids
Inspect exhaust system
#
Inspect fuel lines and connections #
*2: If you drive in dusty conditions, replace the air cleaner element every 15,000 miles (24,000 km).
*3: If you drive primarily in urban areas that have high concentrations of industrial soot and
pollution from diesel-powered vehicles, replace the dust and pollen filter every 15,000 miles
(24,000 km).
*4: If you drive regularly in very high temperatures (over 110°F, 43°C), in very low temperatures
(under -20°F, -29°C), replace every 60,000 miles/100,000 km.
CODE Maintenance Sub Items
1 Rotate tires •
•
•
•
•
•
•
•
•
•
•
•
2 Replace air cleaner element *2
Replace dust and pollen filter *3
Inspect drive belt
3 Replace transmission fluid
4 Replace spark plugs
Replace timing belt and inspect water pump
*4
Inspect valve clearance
5 Replace engine coolant
•
•
•
•
•
•
•
•
Under the Hood
Opening the Hood
1. Park the vehicle on a level surface, and set the
parking brake.
2. Pull the hood release handle under the lower left
corner of the dashboard.
3. Push up the hood latch lever in the center of the
hood to release the lock mechanism, and open
the hood.
4. Remove the support rod from the clamp using the
grip. Mount the support rod in the hood.
When closing, remove the support rod, and
stow it in the clamp, then gently lower the hood.
Remove your hand at a height of approximately
12 inches (30 cm) and let the hood close.
Do not open the hood when the wiper arms are raised. The hood will strike the
wipers, and may damage either the hood or the wipers.
NOTICE
Power
steering fl uid
(red cap)
Brake fl uid
(black cap)
Battery
Engine oil
fi ll cap
Hood release handle
Lever
Support rod Grip
Clamp
Pull
Washer fl uid
(blue cap)
Engine
coolant
reservoir
Engine oil
dipstick
(orange loop)
Radiator cap