HONDA 2015 Odyssey - Owner's Guide (Revised 09/24/2014) User Manual

Page 13

18 |

| 19

SAFETY

Installing a LATCH-Compatible Child Seat

A LATCH-compatible child seat can be installed in each of the second- and third-
row seats. A child seat is attached to the lower anchors with either the rigid or
ﬂ exible type of connectors.

1. Locate the lower anchors under the marks.

2. Place the child seat on the vehicle seat, then

attach the child seat to the lower anchors
according to the instructions that came with the
child seat. Make sure that the lower anchors
are not obstructed by the seat belt or any other
object.

To install a child seat in the second-row center
seat, remove the covers on each lower end of the
seat-back by pulling on the handles.

3. Raise the head restraint to its uppermost position,

then route the tether strap between the head
restraint legs, and secure the tether strap hook
onto the anchor.

4. Tighten the tether strap according to the seat

maker’s instructions.

5. Make sure the child seat is ﬁ rmly secured by

rocking it forward and back and side to side; little
movement should be felt.

6. Make sure any unused seat belt that a child

can reach is buckled, the lockable retractor
is activated, and the belt is fully retracted and
locked.

Second-row seat

Third-row seat

Marks

Handle

Lower anchors

Cover

Flexible type

Rigid type

Second-row outer position

Anchor

Tether

strap

hook

Second row center seat

Anchor

Tether

strap

hook

Installing a Child Seat with a Lap/Shoulder Seat Belt

1. Place the child seat on the vehicle seat.

2. Route the seat belt through the child seat

according to the seat maker’s instructions, and
insert the latch plate into the buckle. Insert the
latch plate fully until it clicks.

3. Slowly pull the shoulder part of the belt all the

way out until it stops. This activates the lockable
retractor.

4. Let the seat belt completely wind up into the

retractor, then try to pull it out to make sure the
retractor is locked. If you are able to pull the
shoulder belt out, the lockable retractor is not
activated. Pull the seat belt all the way out, and
repeat steps 3 – 4.

5. Grab the shoulder part of the seat belt near the

buckle, and pull up to remove any slack from
the lap part of the belt. When doing this, place
your weight on the child seat and push it into the
vehicle seat.

6. Make sure the child seat is ﬁ rmly secured by

rocking it forward and back and side to side; little
movement should be felt.

7. Make sure any unused seat belt that a child

can reach is buckled, the lockable retractor
is activated, and the belt is fully retracted and
locked.

To deactivate a lockable retractor, release the buckle and allow the seat belt to
wind up all the way.