GTCO Bit Pad Two - Users Guide User Manual
Page 39
Bit Pad Two 39
Section C: FCC Considerations
As stated by FCC rules and regulations, Bit Pad Two must be installed and operated in
accordance with the procedures appearing in this manual. In addition, to ensure that EMI
shielding requirements are met, the host’s interface cabling connector must have a metal
shroud, grounded to the host chassis.
Section D: Care and Cleaning
Avoid sharply banging or dropping the tablet, cursor or stylus.
Never immerse any part in fluid.
Disconnect the tablet from its power source before cleaning it.
The Bit Pad Two tablet surface is made of plastic. To clean, use only a cotton flannel cloth
with mild detergent and water. Never use a hydrocarbon cleaner such as acetone or an
abrasive cloth. These mar the tablet finish.
Section E: Service
For technical support and service, contact your local GTCO CalComp by Turning
Technologies representative or GTCO CalComp by Turning Technologies at:
GTCO CalComp by Turning Technologies
14557 N. 82
nd
Street
Scottsdale, AZ 85260
Toll Free: 866.746.3015
Fax: 480.998.1751
If you return a Bit Pad Two for repair, a Return Authorization Number must be on the
outside of the package and on all accompanying paperwork. Obtain a Return Authorization
Number from GTCO CalComp by Turning Technologies Customer Support. When
contacting Customer Support, please have ready the tablet serial number purchase order
number.
NOTE: Do not ship any equipment to GTCO CalComp by Turning Technologies without a
Return Authorization Number.