Great Planes Turmoil FlatOuts EP ARF - GPMA1115 User Manual

Page 13

❏

24. Using an Easy-Touch bar sander with 220-grit

sandpaper, sand a bevel into the edges of the fuselage
diagonal reinforcements at a 45° angle toward the inside.
Glue the diagonal fuselage reinforcements into position
where shown. Be careful not to twist the fuselage as you
glue the parts down.

❏

25. Snap the ailerons onto the wing TE.

❏

1. Install a 2 x 17mm [5/64" x 21/32"] axle and axle

support (D1) onto each landing gear leg. Make sure that
the axles are perpendicular to the centerline.

❏

2. Slide the wheels onto the axles, and secure them with a

wheel collar (D6). The flat side of the wheel collar should be
toward the wheel. Secure the wheel collar with a drop of glue
in the

teeth opposite the wheels. Align the wheels with the

centerline and secure the axles and supports with a drop of
glue through the holes in both sides of the axle supports.

❏

3. Make two wheel pants by gluing the inner and outer

wheel pant parts together. Be sure to make a right and a
left. Glue the inside of both wheel pants to the wheel collars.

❏

4. Snap the tailwheel (D5) into the tailwheel bracket (D4).

Finish the Landing Gear