Great Planes Extra 300S FlatOuts EP ARF - GPMA1114 - Manual (Page 9)

❏
1. Cut the upper and lower vertical fuselage parts and
the right and left horizontal fuselage parts free from their
foam sheets. If using the gearbox included with this kit, or
any other type of “stick-mount” gearbox, cut out all four
sections from the fuselage parts. If using a firewall-mounted,
brushless outrunner motor, cut out only the section from the
lower vertical fuselage.
❏
2. Glue the 5.5 x 250mm [7/32" x 9-7/8"] fuselage tube
doubler over the 3 x 649mm [1/8" x 25-1/2"] fuselage tube.
One end should be flush. From now on, this assembly will be
referred to as the fuselage tube.
❏
3. Slide an E2 fuselage joiner, two F3 fuselage servo
mounts, and another fuselage joiner onto the fuselage tube.
With the tube doubler forward, and the servo mounts hanging
down, the front servo mount should have its flat face on the left,
and the rear servo mount should have its flat face on the right.
❏
4. Position the servo mounts and fuse joiners so that they
align with the precut slots in the upper vertical fuselage.
❏
5. Use glue to attach the fuselage tube to the top half of
the vertical fuselage.
❏
6. Glue the left and right horizontal fuselage halves to
the fuselage tube. Make sure they are perpendicular to the
vertical fuselage.
Assemble the Fuselage
9