Great Planes Dazzler 40 ARF - GPMA1038 - Manual (Page 9)

❏
3. Locate the two aluminum engine mount straps, four
8-32 x 1" bolts, four #8 lock washer and eight #8 nuts.
❏
4. Position the engine in place on the engine mount.
Place the engine mount strap on each side of the engine.
❏
5. Attach the engine to the mount by using the 8-32 bolts,
#8 lock washer and one #8 nut per bolt. When installing the
engine it is important that the crankshaft be 90 degrees to the
firewall. Once the engine is firmly bolted to the mount, attach
a second #8 nut to the bolt. This double-nut installation will
prevent the bolt and nut from vibrating loose.
❏
6. Be sure the outer plastic pushrod extends through the
firewall 1-3/4" [44mm], then glue it in place to the firewall.
❏
7. Install the braided cable into the outer plastic pushrod.
❏
8. Attach the cable to the throttle barrel with the screw
lock connector as shown above.
❏
1. Locate the fuel stopper assembly. Assemble it as shown.
❏
2. Bend one of the two plastic tubes as shown.The tube with
the bend is the vent line, the straight one is for the fuel pickup.
❏
3. Complete the fuel tank assembly as shown. The final
step, once the assembly is inserted into the tank, is to
tighten the screw a few turns to pull the rubber stopper
against the wall of the fuel tank.
❏
4. Remove the hatch to the fuel tank compartment.
Fuel Stopper
Assembly
To Muffler
To Carburetor
Fuel Line
Fuel Clunk
FUEL TANK INSTALLATION
RETAINER
4-40 x 1/4" SHCS
9