Great Planes Curtis P-6E Hawk ARF 1/5 Scale - GPMA1219 - Manual (Page 28)

❏ ❏
11. Bring the elastic cord around the top of the forward
strut and pull it back toward the fuselage. Glue the cord into
the hole next to the hole you started with.
❏ ❏
12. On the side of the fuselage, 1-1/2" [38mm] from the
leading edge of the bottom wing, make two marks 1/2"
[13mm] apart, 1/4" [6.4mm] above the wing. Drill 5/64" [2mm]
holes partially into the fuselage on each of the two marks.
❏ ❏
13. Put a small drop of CA on the cord, then insert it
into forward hole.
❏ ❏
14. Bring the elastic cord around the top of the aft strut
and pull it back toward the fuselage. Glue the cord into the
hole next to the hole you started with.
❏ ❏
15. Cut an elastic cord 40" [1016mm] long. Use CA to
glue the ends together, forming a loop. When gluing the ends
together, overlap the cord approximately 1/2" [12.7mm].
28