Great Planes U-Can-Do SF EP/GP .80 ARF - GPMA1272 User Manual
Page 19
19
washers, four #6 fl at washers and thread locking compound.
The engine mount should be angled down and to the right.
Fit your engine between the mount halves and slide them
together against the crankcase. Remove the engine and
fi nish tightening the mount screws.
❏
12. Attach 6" [152mm] pieces of fuel tubing to each of the
three fuel tank lines.
❏
13. Position the engine onto the mount so the face of the
drive washer is 5" [127mm] from the fi rewall. Use a Dead
Center Hole Locator (GPMR8130) to mark the location of
the engine tab mounting holes onto the engine mount rails.
❏
14. Use four 6-32 x 3/4" [19mm] machine screws, four #6
lock washers and four #6 fl at washers to attach the engine
to the engine mount.
❏
15. Mount the muffl er to the engine and connect the vent
and carb fuel lines to the engine. Plug the vent /fi ll line (if
applicable) with the included nylon fuel line plug. The plug
should stay in place during fl ight and only needs to be removed
to fi ll or drain the fuel tank.
❏
16. Mount the throttle servo in the middle of the servo tray.
The servo spline should be toward the rear of the plane. Be
sure to reinforce the mount screw holes with thin CA.