Great Planes Factor 3D ARF - GPMA1552 - Manual (Page 11)

11
pushrod where it crosses the aileron servo arm. Make a 90°
bend at the mark. Cut the pushrod 3/8" [9.5 mm] past the
bend. Attach the pushrod to the elevator servo arm with a
nylon Faslink.
❏
12. Repeat steps 9-11 for the rudder pushrod installation.
Install the Motor, Speed Control
and Receiver
❏
1. Assemble your motor following the instructions that came
with it. Install the motor to the fi rewall with four 4-40

3/8" [3

10 mm] machine screws, #4 [ 3 mm] lock washers and #4
[ 3 mm] fl at washers. Be sure to apply a drop of thread locker
to the threads on each screw.
❏
2. Cut a piece of the adhesive-backed hook and loop
fastener to fi t the speed control and apply one side of it to
one side of the speed control and the other half to the bottom
of the battery tray in the fuselage. Install the Velcro strap
(without adhesive backing) through the slots in the battery
and around the speed control. Plug the leads from the motor
into the speed control.