Great Planes ElectroStik EP ARF - GPMA1574 - Manual (Page 6)

6 6
PREPARATIONS
Use a covering iron with a covering sock on medium/high heat
to tighten any loose covering if necessary. Apply pressure over
sheeted areas to thoroughly bond the covering to the wood.
ASSEMBLY
Assemble the Wing
❏
1. Install the 20-7/8" [530mm] carbon fi ber wing joiner
tube and the 1" [25.4mm] steel alignment pin into the right
wing panel as shown.
❏
2. Carefully slide the left wing panel in place as shown.
❏
3. Fasten the wing halves together using the two included
nylon straps and four #2 x 3/8" [9.5mm] self-tapping screws
as shown.
❏
4. Install the rubber grommets and eyelets that were
included with the servo and place it in the aileron servo tray
as shown. Note: You may need to use a bent paper clip to
pull the servo connector out of the wing.
❏
5. Drill a 1/16" [1.6mm] hole through each mounting
hole location. Do not drill all the way through the wing;
the holes should be just deep enough to accommodate the
length of the servo mounting screws.
❏
6. Install the servo into the aileron servo bay using the
servo mounting screws that came with your servos, with the
servo spline toward the front of the wing.
6