Cub Cadet 945 SWE - Manual (Page 11)

Snow thrower controls and features are described below and
illustrated in Fig. 4-1.
NOTE: For detailed information on all engine controls, refer to
the separate Engine Operator’s Manual supplied with this unit.
Speed Selector Shift Lever
The speed selector shift lever is located in the right
side of the handle panel and is used to determine
ground speed and direction of travel.
Forward
There are six forward (F) speeds. Position one (1) is
the slowest and position six (6) is the fastest.
Reverse
There are two reverse (R) speeds. One (1) is the
slower and two (2) is the faster.
Heated Hand Grips
Can be turned on/off by a switch found on the dash
panel.
Skid Shoes
Position the skid shoes based on surface conditions. Adjust
upward for hard-packed snow. Adjust downward when
operating on gravel or crushed rock surfaces.
Augers
When engaged, the augers rotate and draw snow into the auger
housing.
Chute Assembly
Snow drawn into the auger housing is discharged out the chute
assembly.
Headlight
The headlight is located on the front of the handle panel.
Figure 4-1
Chute Assembly
Auger
Auger
Housing
Skid Shoe
Clean-out Tool
Drive Control
Auger Control
Chute
Directional
Control
Wheel Steering Control
Heated Hand Grip Headlight
Speed Selector Shift Lever
Two-way Chute Control™
Controls and Features
4
11