GME TX655 User Manual
Page 15

t X 6 5 5 i n s t r u c t i o n m A n uA l
PA G E 1 5
for 5 seconds to store your choice. The
icon will be displayed
whenever Key Beep is active.
RooM MoNiToR
The Room Monitor works in a similar way to the hands Free (VOX)
mode but uses only the highest microphone sensitivity setting. When
activated, the Room Monitor listens for sounds in the room. Any short,
brief sounds are ignored but a continuous sound lasting 5 seconds
or more will cause the radio to transmit for 15 seconds. If the sound
persists, the radio will continue to transmit for a further 15 seconds.
To Activate the Room Monitor Mode
Press the MODE button repeatedly until ‘bb’ is displayed. Use the
or buttons to change the setting to ‘on’ or ‘oF’. Press the
PTT or wait for 5 seconds to store your choice. The
icon will be
displayed whenever the Room Monitor is active.
NOTE:
The Squelch must be closed for the room monitor to
operate correctly.
IMPORTANT: The Room Monitor function is not a replacement for
regularly checking the safety and security of children. If you move out
of communication range you will not hear transmissions.
iNTeRCoM
The intercom function allows you to communicate with another
TX655 radio using an optional intercom connector
(available separately).
To Activate the Intercom Mode
Press the MODE button repeatedly until ‘it’ appears. Press the
or buttons to change the setting to ‘on’ or ‘oF’. Press the PTT or
wait 5 seconds to store your choice. The ‘InT’ icon will be displayed
when the intercom function is active.
sCRAMBleR
Your radio incorporates a simple voice scrambler using band
inversion. The scrambler is compatible with the majority of scramblers
used by other manufacturers, allowing you to enjoy scrambled
communications with both gME or non‑gME radios. Once the
scrambler has been activated your transmission and reception will
only be intelligible to others using the same scrambler technology.
To Activate the Scrambler
Press the MODE button repeatedly until ‘Sr’ appears. Press the
or buttons to change the setting to ‘on’ or ‘oF’. Press the PTT or