GIN Fuse pilot - Manual (Page 17)

17
Rescue Installation Guide
The Fuse Pilot rescue is located behind the pilots seat. The handle can be placed on the left or
right side with a velcro bridle tunnel running along both sides of the harness to allow the pilot to
customize the harness to their needs. It is very important to properly install the rescue
parachute. If the parachute is not folded correctly or the lines are not placed properly then a
serious if not fatal accident could result. If you have any doubts speak with your instructor or GIN
dealer.
Using the extra para line provided with your harness, pull the built in loops through the
grommets of the rescue container flaps. Close the rescue container flaps in the order shown in the
photos below. Secure the rescue container flaps by placing the metal release pins through the
loops as shown. Insert each side of the rescue handle into its neoprene sleeve and secure with the
attached Velcro.
WARNING: When installing the
reserve make sure the reserve
handle attachment is facing out
away from the harness and the
reserve lines are facing in.
1 2 3 1 22 3
Place the rescue attachment line in a
“zig-zag” pattern at the bottom of the
pouch
Place the rescue into the pouch with the
rescue handle facing out