GIN Fuse pilot - Manual (Page 14)

14
Rescue Installation and compatibility check
Attaching the rescue deployment bag to the harness deployment handle
The rescue container of the Fuse Pilot comes with its own deployment handle. This handle and
its strap must be connected to the deployment bag of the parachute. In particular, check the
length of the strap connecting the rescue deployment handle to the rescue inner container. It
should be long enough that the reserve can be extracted without the danger of the pins not being
pulled before the strap tightens on the reserve, but not so long that there is excessive slack that
extends the movement required for deployment.
The deployment bag of other manufacturers’ rescue systems (i.e. non-GIN rescue systems)
may have different loop positions which may cause a deployment failure. Be sure to contact
your parachute dealer or a qualified professional to check the connection, position and secure
deployment, and refer to the rescue manual for details.
Rescue container volume
The rescue should fit comfortably in the container. The rescue should be held so that it can’t
move around, but not too tightly that extraction becomes difficult. If necessary, place a piece of
foam behind the rescue to reduce the depth of the container.