GIN Fuse pilot - Manual (Page 13)

13
Rescue Installation and compatibility check
Gin Gliders recommend that rescue installation is performed properly by a competent person.
The Fuse pilot is compatible with the GIN Yeti tandem rescue. Other manufacturer’s rescues
may be used as well but must be checked for compatibility by a professional.
Every first installation of a rescue system into the harness (that means every new combination
of harness and rescue system) must be checked by a qualified paragliding professional for
compatibility. To verify the installation, you must perform a test deployment by sitting in a
simulator.
Rescue parachutes should be repacked at least every 150 days; so installing your rescue in a
new harness may also provide a good opportunity for a repack. After every repack of the rescue
parachute you should also do a compatibility check. Make sure that the rescue parachute can be
released from the rescue container in the harness—it must be done by you, the pilot, sitting in the
harness hanging from a simulator.
WARNING: If you are in any doubt
about any aspect of rescue
installation, seek professional
advice.
IMPORTANT: You must perform a
test deployment from a simulator
to verify the installation.
Before you fly
Make sure your dealer has checked the harness for completeness and basic settings. Your
harness must be assembled by a suitably qualified paragliding professional, for example, your
instructor.