GIN Boomerang 10 - Manual (Page 14)

Boomerang 10 14 / 62
Overload
The CCC describes the weight measurement with: “All weights are subject to an acceptable
tolerance of ± 2kg”. Therefore a slight overload of the wing would be within CCC tolerances.
However, flying over the maximum weight further increases the dynamic flight behaviour. High
performance wings in particular start to lose their floating ability: in small bubbles, the wing
has more horizontal momentum and less tendency towards lifting. A test flight is always
recommended if in doubt.
TIP: Check your total flying weight by standing on weighing scales with all your equipment
packed into your rucksack. Remember that ballast can also be used to adjust wing loading to the
conditions.
First flight
Carry out your first flights only during stable weather, and in a familiar area or on a training
slope. You should steer gently and carefully to begin with so that you can become accustomed
to the reactions of the glider without stress.