Galaxy Audio AS-1500 - Manual (Page 6)

Adjusting Left and Right Balance:
Press or to adjust left and right earphone balance,
as shown in Diagram . “-0-” indicates center balance.
Press “SET” button, “GROUP” will flash, press or to
select suitable frequency group number, as shown in
Diagram on the left. Then press “SET” again,
“CHANNEL” flashes, press or to select suitable
channel, as shown in Diagram on the left.
Four level battery status indicator, as shown in Diagram
. Replace batteries when indicator blinks. ”Low
Battery” LED (page 4) will also light at this point.
Press “SET” button 3 times, “EQ” will flash, press or
to select EQ mode. “ON” (Offers more high-end
response: 6dB boost at 10KHz), “OFF” (Is Normal, Flat),
as shown in Diagram .
Press “SET” button 4 times, “LIMITER” will flash, press
or to select Limiter “On” or “Off”, as shown in
Diagram .
Press “SET” button 5 times, “ ” will flash, press or
to select Lock or Unlock, as shown in Diagram .
Press “SET” button 6 times.
/
Displays Battery Status, RF/Audio Level, Stereo/Mono
Mode, EQ Mode, Lock Status, Limiter Mode and
Selected Frequency, as shown in Diagram .
Bodypack Receiver Programming
Select a Group and Channel:
Battery Indication
Equalization Setup:
Limiter selection:
Locking Selection:
Stereo/FOCUS selection:
Full Display
When the receiver is set to
stereo operation, the left-right signals are available as
usual. When the receiver is set to FOCUS operation, the
left-right signals are mixed and are available as a mono
signal in both headphone channels. Use the
rocker
buttons to adjust the relative levels of the two separate
channels in the mixed mono signal, as shown in
Diagram . Press "ESC" after any programming to exit
menu and return to full display.
1
2
3
4
5
6
7
8
9