Galaxy Audio LA4/LA4PM Yoke Bracket - Manual (Page 2)

MOUNTING PROCEDURE:
PREVIEW: After evaluating the mounting surfaces and obtaining the
appropriate fasteners, the installation will consist of the following steps, in
order:
1. Mounting the yoke bracket to the wall or ceiling.
2. Joining the cabinet with the bracket assembly.
4. Installing the safety cable.
TOOLS REQUIRED: You will need at least these tools for installation:
#3 Phillips Screwdriver
Large Crimping Pliers
Tools to secure the fasteners selected for the wall/ceiling mounting (drill,
screwdrivers, etc.)
Carpenter's Level for precise positioning of the speaker. (Optional)
Note: It is often helpful to have another person available to hold the
speaker in place during the tightening procedure.
INSTALLATION:
ATTACHING THE YOKE TO THE MOUNTING SURFACE:
Note: First choose the tilt angle holes in the yoke to determine if the
yoke will be mounted to the wall upside-down or not. (See Joining
Cabinet to Yoke section.)
Position the yoke bracket onto the wall or ceiling at the location you have
selected, preferably to a stud, joist or other structural member rather than
only to drywall or other non-structural material.
Make sure there will be enough clearance to tilt the speaker to the desired
angle. Using the yoke as a template, mark the four hole locations.
NOTE: Check that any holes you drill and the fasteners will not
interfere with any wiring, plumbing, etc. that may be behind the
mounting surface.
Prepare the mounting surface and the four holes for the fasteners. Pull
speaker wires through the mounting surface and feed thru the center hole in
the bracket (if applicable). Secure the yoke to the wall. Do not over tighten
fasteners!
JOINING THE CABINET TO THE YOKE:
1. Remove the four plastic threaded inserts, from the left and right sides of
the center of the cabinet, with a small flat blade screwdriver. (See photo
below)