Galaxy Audio MSPA5 - Manual (Page 15)

MOUNTING YOUR NANO SPOT (NSPA), MICRO SPOT (MS5)
or HOT SPOT SERIES SPEAKERS
The Micro Spot (MS5), and the Nano Spot are supplied with a bracket
kit that allows either stand or wall mounting. Wall mount options are
available for the Micro Spot (MS5) and PA6S HS7 from any Galaxy
Audio dealer, or online at
www.galaxyaudio.com
Stand Mounting Nano Spots and Micro Spots
To install the yoke bracket, attach the SA-1 to the yoke bracket using the
included wing screw and washer as shown in picture below [A.1]. The yoke
bracket assembly can now be screwed on to the microphone stand. Remove
the two plastic threaded inserts from the T-nuts in each side of the Micro Spot
with a small flat blade screwdriver. Place the Micro Spot into position so that
the wing screws at the ends of the yoke line up with the T-nuts in the cabinet.
Tighten the wing screws by hand.
[A.1]
(SA-1)
Stand Adaptor
Top view of wall mounted NSPA
with 90º connectors
12
STAND MOUNTING TIP:
Permanent piece and the collar will
not allow HOT SPOT
™
to sit deep enough
THE SA-1 WILL ALLOW YOU TO SECURELY PLACE
YOUR HOT SPOT ON ANY MICROPHONE STAND.
SA-1 needed
SA-1
Stands that need SA-1’s
K&M™ series stands
AKG™
Beyer™
Sennheiser™
Ultimate™
No SA-1 needed unless
using a yoke mount
Atlas and SHURE
™
stands
allow HOT SPOT
™
to sit
deep enough on the stand
Stands that don’t
need SA-1’s
Atlas™
SHURE™
All HOT SPOT's, both powered and un-powered, have a built in microphone stand
mount: just slide the microphone stand into the receptacle on the bottom of the
HOT SPOT. Some microphone stands may require the SA-1 adaptor.