Galaxy Audio HSVC Hotspot Yoke Bracket - Manual (Page 3)

INSTALLING T-NUTS FOR GALAXY AUDIO BRACKET
1. Remove six screws from bezel on front of unit. If installing on a PA5XD remove nut and one
additional screw from back of unit.
2. Remove bezel from shell
3. Disconnect speaker wires leading from speakers to shell from the speakers.
(Not applicable if installing on a PA5XD).
4. On each end of the unit, drill a 5/16" hole in the center of shell and 1" from the front edge.
(See illustration #1 and attached template (Pg 5.) for approximate hole placement).
5. Insert 1/4 - 20 propeller nuts (T-nuts) from the inside of the shell and drive them in with a hammer.
6. Drill a 5/32" hole in the back of the shell to mount the safety cable clamp (see illustration #2
and attached template (Pg 6.) for approximate hole placement).
7. Install the clamp with the supplied 6-32 x 1/2" bolt and nut.
8. Reassemble and test
3