Combi 8000 Series - Manual (Page 18)

17
Securing Base With Vehicle Seat Belt:
Refer to vehicle owner’s manual to identify the seating locations which can be used with a
car seat. Check for specific instructions for car seat use.
After selecting a seating location, adjust vehicle seat back into most upright position.
Place base with car seat attached rear-facing on vehicle seat with belt path tabs towards
vehicle seat back (fig. a).
Adjust recline of car seat. Line inside recline indicator MUST be in green striped
zone (fig. a). If line is not in green striped zone, adjust base (see “Base
Adjustment” section), and recheck recline of car seat. Repeat until recline
indicator is in the green striped zone.
If base can not be adjusted to locate the line in the green striped zone:
1. Try a different seating position.
2. Do not use this infant car seat.
NOTE: Vehicle must be parked on horizontal surface during this installation.
Remove car seat from base.
Route vehicle seat belt through base:
a. Locate vehicle seat belt buckle that will be used to secure the base and
arrow on the blue belt lock-off.
b. The arrow on the belt lock-off must point toward the vehicle buckle that
will be used to secure the vehicle belt (fig. b).
(fig. a)
(fig. b)
WARNING
DEATH or SERIOUS INJURY can occur
• Not all vehicle seat belts can be used with a car seat. Read vehicle owner’s manual and “Vehicle Seat
Belts” section in this manual.
2
3
4
5
6
1
Vehicle
Buckle
TICS1203e (EN).qxd 4/4/05 4:15 PM Page 18