Combi 8000 Series - Manual (Page 17)

16
Removal Of Base Installed With LATCH:
Loosen lower anchor belt. Pressing down in center of base to reduce tension on lower
anchorage belt push adjuster slide button and loosen belt.
Press and hold the connector retainer spring .
Push connector in, then rotate connector , and pull out 3 to unhook from the vehicle
anchorage (fig. a). If the connector can’t be rotated, push in and lift the connector to
unhook from the vehicle anchorage.
Repeat to remove connector on opposite side.
Storage Of Lower Anchorage Belt And Lower Anchor Connectors:
When not using the LATCH System, fold the anchor belt and lower anchor
connectors and place inside LATCH compartment in base (fig. b).
(fig. b)
(fig. a)
1
2
3
LATCH
Compartment
1
2
3
1
2 3
Base
TICS1203e (EN).qxd 4/4/05 4:15 PM Page 17