Combi 8000 Series - Manual (Page 15)

14
Refer to vehicle owner’s manual to identify the seating locations with LATCH
System. Select the seating location to be used and locate the vehicle lower
anchorages at the seat bight.
A LATCH Anchorage System with 280 mm (11 inches) spacing may not be available in
your vehicle in the rear center seating position. If use of the rear center position is
preferred, use the vehicle seat belt to secure the car seat. See “Securing Base
With Vehicle Seat Belt” section.
Remove car seat from base.
Remove the LATCH lower anchor belt with lower anchor connectors from the LATCH
compartment in base (fig. a).
Lengthen lower anchor belt. While pressing down on release button on top of
belt adjuster, pull belt to extend the length of lower anchor belt (fig. b).
Position the lower anchor belt with the belt adjuster slide buttons facing away from the
car seat. If the adjuster is not in that position, turn the belt and adjuster over.
Place the lower anchor belt under both belt path tabs in the base (fig. c). Belt Lock-off will
be under LATCH belt. Check that the belt is not twisted.
Adjust vehicle seat back into most upright position.
Place base rear-facing in the vehicle seat location
selected with LATCH belt toward vehicle seat back
and centered between the vehicle lower anchors
(fig. d).
(fig. a)
(fig.d)
(fig. b)
Lower
Anchor Belt
Adjuster
Slide Button
Pull
1
3
4
5
6
7
2
(fig. c)
LATCH
Compartment
8
LATCH
Lower Anchor
Belt
Adjuster
Belt
TICS1203e (EN).qxd 4/4/05 4:15 PM Page 15