Philips AZ 2908 - Manual (Page 11)

RADIO
Tuning to radio stations
B
LU
1 Select the tuner by pressing the CD«TAPE»TUNER button
several times until
eeei
appears on the display.
2 Select the wave band by using the BAND selector.
-► Display indication: the selected waveband
3 Press TUNING r« orw for approx, one second and then release
the button.
-► The radio automatically tunes to a station with sufficent
strength. Display indication during automatic tuning: S.- c A
4 Repeat this procedure until you find a desired station.
To tune to a weak transmitter briefly press TUNING or as
often as necessary for optimum reception, or until the correct
frequency is indicated in the display.
Improving the RADIO reception
• For FM and SW, pull out the telescopic antenna. To improve the
signal, incline and turn the antenna. Reduce its length if the
signal is too strong (very close to a transmitter).
• For AM, MW and LW, direct the built-in antenna by turning the
whole set. The telescopic antenna is not needed.
Em
» n o c n
I uuuu
C_ _L
_(/ LI I
Switchable tuning grid (not all versions)
In North and South America the frequency step between adjecent
channels in the AM band is 10 kHz. In the rest of the world this
step is 9 kHz. Usually this frequency step has been preset in the
factory of your area. (/01 versions only)
In some versions the frequency step can be changed:
• Keep the BAND selector button pressed for more than 5
seconds.
-► The display shows either IS Sr !do:'3 Sr Id.
Programming radio stations (29 preset stations)
You can store up to 29 radio stations in the memory. When tuning
to a preset station, the preset number (1 to 29) is indicated in the
display.
1 Select the tuner by pressing the CD*TAPE»TUNER button
several times until EEHa appears on the display.
2 Tune to a desired station with TUNING or^w, as described
earlier.
-► If the frequency is already stored in the memory, the preset
number will be displayed.
11