Philips G96SVCAA01 - Manual (Page 7)

S ktting Y our R kmotk T o W ork VCR s , C onvkrtkrs - S karch
y our TV remote can be set to work
your VCR or Cable Converter by
what is called the SEARCH method.
If the "REMOTE CODE" number
method shown in the previous section
did not set your remote to work your
VCR or Converter, then follow the easy
steps listed below.
Please read through steps 1-4 before
beginning.
______________
( BEQIW)
Press the POWER button on the
I VCR or Converter to turn the unit ON.
<|> Place the TVA'CR/CBL switch
on the remote in the desired position
(VCRorCBL).
Stand at least six feet away from the
front of the VCR or Converter.
Point the remote toward the unit.
HOLD DOWN the A/CH and
desired POWER (VCR or CBL
Converter) buttons at the same time.
KEEP HOLDING BUTTONS DOWN.
Watch the Channel Indicator on
the unit.
Channel Numbers will SCAN UP
when the unit has been identified. This
may take up to two minutes.
Release the A/CH and POWER
(VCR or CBL) buttons as soon as
channel numbers start to scan up. The
code has been identified and the
remote is ready to operate the VCR or
Converter.
S mart H ki . p
Remember, a minute or
two can seem very long, but
*the code should be located
within two minutes.
Don't let the VCR scan up more than
five channels. If you do the remote
may pass up the right code and anoth­
er two minute search cycle will have
to be repeated.
If no channel change happens within
two minutes, repeat steps 1-4. Should
a channel change still not occur, the
remote will not work with the desired
unit.
Don't let the VCR or Converter
scan up more than five channels
(in Search mode).