Connecting the speakers, Speaker cable, Connectors on the speakers – Philips FB 602 User Manual
Page 7: Connections on the amplifier/receiver, N ir
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6. CONNECTING THE SPEAKERS
Centern
front
TV right
surround
left
surround
right
(O
O)
c
Important! Always switch off your amplifier/recelver before making any connections I
SPEAKER CABLE
• Preferably use special speaker
cable having a section area of at
least 0.75 mm2.
• Strip off the insulation from the
end of each of the two wires;
approx. 7 mm.
• One of both speaker wires is
usually marked with a colour or a
sleeve so that you can distin
guish between them. In order to prevent phase problems,
make a habit of connecting the marked (coloured) wire to
the coloured © speaker terminal and the unmarked wire to
the black © speaker terminal.
CONNECTORS ON THE SPEAKERS_________________
• At the rear or bottom of the speakers you will find the screw
connectors, marked © and 0.
• Connect the marked or sleeved speaker wire to the ©
terminal, and the unmarked wire to the © terminal of the
speaker.
CONNECTIONS ON THE AMPLIFIER/RECEIVER
The loudspeaker connections on the amplifier or receiver may
be screw connectors or click-fit connectors.
• At the rear of the amplifier/receiver you will find a red or ©
terminal and a black or © terminal for each speaker.
• Connect the marked or sleeved speaker wire to the red or ©
terminal, and the unmarked wire to the black or © terminal
of the amplifier/receiver.
%
mm -1/4"
%
n ir
10
mm -
After connecting the speakers, do not forget to adjust the
relative sound level between the speakers, see chapter
'Adjusting the relative speaker balance'.