Philips AE3350 - Manual (Page 4)

Installation/Radio General
CONTROLS ENVIRONMENTAL NOTE
(T) Telescope aerial
(D TUNING indicator
(3) Station selection (TUNING)
© Volume (VOLUME)
(D On-/Off switch (POWER)
® Wave range switch (FM/MW/LW/SW 1 - 9)
© Headphone connection
For headphones with 3.5 mm jack plug and 26-
32 Ohm impedance.
© DC3V
@ POINTER
AERIALS
FM and SW reception with the telescope aerial
For FM reception, pull out the aerial and rotate
it to a favourable reception position.
The telescope aerial should be vertical for SW
reception.
MW and LW reception with the built-in ferrite-
rod aerial.
Adjust the unit to optimum reception by turning
around the vertical axis.
VOLTAGE SUPPLY
1. Via 2 miniature cells 1.5 V (lEC R6/UM3/AA).
• Insert the batteries in the given polarity.
• Immediately remove used batteries.
(Danger of leakage)
2. Via a commercial power pack with coaxial plug
5.5 mm 0 (output voltage 3 V =; network
voltage 220 - 230 V 50/60 Hz).
The inserted batteries are automatically
switched off at connection.
1. All redundant packaging material has been
omitted. We have done our utmost to make the
packaging easy to separate into three mono­
materials:
- cardboard (box)
- expandable polystyrene (buffer)
- polyethylene (bags, protective foam sheet)
Please observe the local regulations regarding
the disposal of these packaging materials,
2. Your set consists of materials which can be re­
cycled and reused if disassembled by a special­
ized company. Please inquire about local regula­
tions on how to hand in your old set for
recycling.
3. Do not dispose of exhausted batteries with
your household waste. Please inquire about
how to dispose of batteries according to local
regulations.
MAINTENANCE
Clean housing only with soft, dust-catching
rags.
Don't use harsh polishing or cleansing
materials.
Protect the unit from all moisture (e.g. dropped
and sprayed water).
Technical data: See page 3
- Output; 380 mW top performance
- Intermediate frequencies: 10.7 MHz and 460
kHz
- Subject to technical and optical alterations.
RADIO RECEPTION
• Set the POWER switch to ON.
• Select the waveband using the BAND selector.
• Tune to a station using the TUNING knob.
- The tuning indicator lights up for good
reception and optimum tuning. The indicator
doesn't light up if the reception is bad or if the
batteries are weak.
• Adjust the volume with the VOLUME control.
• Switch off the built-in loudspeakers if you wish
to connect the headphones.
• The set is switched off when POWER is in
position OFF.
Type information is located under the hinged
support on the back of the unit
This set complies with the radio interference
requirements of the European Community