Philips CD 335 - Manual (Page 5)

INSTALLATION
POWER SUPPLY SETTING
Check that the type plate on the rear of your
player indicates the correct supply voltage.
If your mains supply voltage is different, con­
sult your dealer or our Service Organisation.
Certain versions of this player are equipped
with a voltage selector (3), which enables you
to set the player to the correct mains voltage
yourself. When changing the voltage setting, it
IS also necessary to change the mains fuse (1)
to one of the correct rating: T200 mA (slow
blow fuse) for 110/127 V; T100 mA (slow blow
fuse) for 220 V - 230 V/ 230 V - 240 V.
CONNECTIONS fF/g. 1)
1 Mains fuse holder (not all versions)
See 'Power supply setting'.
2 Mains socket
• Insert the plug of the mains lead (supplied) into
the mains socket.
• Connect the other end to your mains supply.
- The player is now switched on immediately.
3 Voltage selector (not all versions)
See 'Power supply setting'.
4 ANALOGUE OUT
For the connecting cable to the amplifier.
• Insert a red plug into the 'R' socket and the
other plug into the 'L' socket.
• Insert the two other plugs into the correspon­
ding sockets of the CD or AUX input of your
amplifier. You can also use the TUNER or TAPE
IN connection, but never the PHONO input!
5 EASY LINK
- For connecting up the equipment in a PHILIPS
HiFi system with its own remote control sys­
tem.
- For connecting the remote control receiver EM
2200, available as an accessory. (Not available
in the U.K.)
- For connecting the player to a PHILIPS cassette
deck with a CD DUBBING function. See also
'CD DUBBING’ on page 9.
FITTING A MAINS PLUG (U.K. only)______________
The wires in the mains lead are coloured in accor­
dance with the following code:
Blue - Neutral; Brown - Live.
As the colours of the wires may not correspond
with the terminal identification in your plug, pro­
ceed as follows:
• Connect the brown wire to the terminal marked
'L' or coloured brown or red.
• Connect the blue wire to the terminal marked
'N' or coloured blue or black.
S)
c
Ul
No connection should be made to the earth
terminal of the plug!
For 13 A plugs, conforming to BS1363, use a 3
A fuse.
For other plugs, use a 5 A or lower fuse in the
plug, adaptor or at the distribution board.
NOTE!
When using the player in the Philips HiFi
system FS 320, it is recommended that the units
are stacked as follows (from top to bottom):
7 record player FP 320;
2 receiver FR 320;
3 CD-player CD 335,
4 cassette deck FC 320.
This stacking order gives the optimum sound
quality and prevents any interference from out­
side