Philips CD602 - Manual (Page 6)

Operation
гл
э
(Q
w‘
3"
FUNCTIONS AND OPERATION
Inserting the disc
• Press POWER button to switch the unit
on.
• Press OPEN/CLOSE to open the CD
tray.
- "OP" flashes on the display.
• Insert the CD, printed side up, in the
tray (See Fig. 4).
• Press OPEN/CLOSE again to close the
CD tray.
The CD-player starts and scans the
contents list of the CD. After 3 seconds,
the total number of tracks appear on the
display followed by "1".
Playing the entire disc
• Press PLAY/PAUSE ►!! on the unit.
- Playback starts with the first track.
- The ► PLAY indicator lights up and
the display shows the current track
number.
- When all the tracks have been played,
the CD player stops and track 1 is
shown on the display.
• To stop playback, press STOP ■ on the
unit.
• Press POWER button to switch the unit
off.
Interrupting play
• Press PLAY/PAUSE ►!!.
- The ► PLAY indicator flashes on the
display.
• Press PLAY/PAUSE ►il again if you
want to resume playback.
- The ► PLAY indicator stops flashing.
Stopping play
• Press STOP* if you wish to stop playback.
- The ► PLAY indicator goes off.
- Track 1 will now appearin the display.
• Press OPEN/CLOSE to remove the CD.
Playing in a desired order (Program)
(Only possible in STOP mode)
By programming the player, you can play up
to 16 tracks in any desired order. If you
exceed the maximum of 16 tracks, the last
track number entered will not changed in the
display.
• Pressi« or»! briefly (lessthan 0.5 second)
to locate a particular track.
• When you have found the correct track
number, press MEMORY to store it in the
memory.
- The fiEftuRa indicator lights up.
• Press h« or» briefly to locate the next
track to be programmed.
- The track number flashes on the dis­
play.
- Press MEMORY again to store it.
• Repeat this procedure to select other
tracks that you wish to programme into
the memory.
Notes:
- If the MEMORY button is pressed during
the STOP mode before any track is
entered, track number 1 will be entered
as the first track in the program.
Playing a program
• Press PLAY/PAUSE ►!!.
- Playback starts with the first track of
the program.
- When all tracks have been played, the
display shows the last track of the
program.
Reviewing the program
(Only possible in the STOP mode)
• To review the tracks which you have
programmed, press MEMORY once.
- The programmed tracks will be dis­
played in running sequence.
Erasing a program
• To clear all programmed tracks, press
STOP ■ twice.
Note:
-
Opening and closing the CD tray and
switching the unit off will also cancel the
programme.