Philips 20PV 184 - Manual (Page 9)

2. PLAYBACK
^ Insert a cassette into the cassette slot.
o Press the I ^ pi -AY 1 playback button.
0 Picture search: Now press the [S] (rewind) or I
(wind) button once or several times.
Q Interrupt; Press the I stopb ] button.
O Wind: Stop the tape and press the I ^ I (rewind) or the
I ^ I (wind) button.
0 Eject: Press the I — I button on the set.
Note: Some functions switch off automatically after a
while (e.g.: Pause, Still Picture, Scanning). This helps to
protect the cassette and prevent unnecessary power
consumption.
* With this set you can play back cassettes that have
been recorded on another TV combi in the NTSC
standard.
* if you load a cassette with erase protection, the TV
Combi starts playback automatically.
* The picture quality is affected during scanning. The
sound is switched off.
* Remove the cassette before transporting the TV
Combi.
Still picture
^ Press the I I button. You see a still picture.
Interference stripes will appear.
Each time you press the I stilln ^ I button again the pic­
ture will move on one step.
Continuous playback
O Press the I menu I button.
@ Select and confirm the 'SPECIAL' line.
Q Select the 'REPEAT PLAY' line. Switch on the continuous
playback.
Q Press the I menu I button.
o
Start the continuous playback with the
I
playback button.
■PLAY
0 If you want to cancel the function, stop the continous
playback in the 'REPEAT PLAY' line.
Tape position/Index search
Tape position: If you press the I Ok | button the tape posi­
tion will be shown in the display during Wind, Rewind,
Record, Playback and Pause/Stop.
Index search: Every time you start to record, the tape is
marked with a code mark.
^ Press the I index W | button. Press the I I button to
select the next code mark or the I I button for the
previous code mark.
0 Once the TV Combi finds the code mark or unrecorded
area it will automatically switch to playback.
Note: When you press any tape transport button (e.g.:
the I ^ I or I I button) this search function will be
stopped.
* You cannot use this function with recordings made on
another video recorder that does not have this function.
^ During playback press the I menu | button.
^ Select and confirm the 'SPECIAL' line.
^ Select the 'TRACKING' line.
© Press the I I or I ► I button until the playback
quality is at its best.
o Press the I menu I button. This setting will remain until
you remove the cassette.
Q Cleaning function: Press the I MENh I button.
Q Select and confirm the 'SPECIAL' line.
O Select the 'CLEANING'line.
Eliminating picture interference
0 Press the l_Ok I button. A blue screen appears for a few
seconds.
(E) Wait until the blue screen disappears and press the
I MENU I button.
Note:
* Some hired cassettes may have a poor picture/sound
quality. This is not a fault in your set.