beautypg.com

Installation, Important for the united kingdom, Important notes for operation – Philips 20PV 184 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

1.

INSTALLATION

Important for the United Kingdom

This apparatus is fitted with an approved moulded 13 Amp

plug. To change a fuse in this type of plug proceed as follows:

^ Remove fuse cover and fuse.

0 F

ix

new fuse which should be a BS1362 5A, A.S.T.A. or BSI

approved type.

^ Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets, it

should be cut off and an appropriate plug fitted in its place.

If the mains plug contains a fuse, this should have a value of

5A. If a plug without a fuse is used, the fuse at the distribution

board should not be greater than 5A.

Note: * The severed plug must be destroyed to avoid a

possible shock hazard should it be inserted into a 13A

socket elsewhere.

Connecting the cables

O Insertthe aerial plug into the I3

e

I1 socket.

Q Insertthe plug of the mains cable into the wall socket.

0 Switch the set on. The power switch I 1 is located on

the leftside panel of the set.

How to connect a plug:

The wires in the mains lead are coloured in accordance with

the following code:

BLUE-'NEUTRAL'('N')

BROWN-'LIVE'('L')

0 The BLUE wire must be connected to the terminal which is

marked with the letter 'N' or coloured BLACK.

0 The BROWN wire must be connected to the terminal

which is marked with the letter 'L' or coloured RED.

0 Do not connect either wires to the earth terminal in the

plug which is marked with the letter 'E' or by the safety

earth symbol I * I or coloured green or green-and-

yellow.

Before replacing the plug cover, make certain that the cord

grip is clamped over the sheath of the lead - not simply over

the two wires.

Important notes for operation

We advise you, from now on, to switch the set to standby

using the I

standby

(ITI button on the front of the set or on

the remote control.

When the set is in the standby mode, a small red lamp on
the left of the front of the set will be alight.

You can switch on with the I

stqp

M 1 button, the

I 0-9 I buttons or by inserting a cassette.

Attention; When you use the power switch I ^ I on the
side panel, you have completely switched off the set from
the mains power supply. No programmed recordings will
then be made. The red lamp on the left of the front of the
set will not be alight. After a few hours, the date and clock

settings will be lost.

Attention: Before you switch off the appliance with the

power switch I ^ I, remove the tape by pressing the

I — I button.

Keep your TV Combi connected to the mains and the
power switch in 'on' position at all times to ensure that
programmed recordings can be made and that the

television functions normally. The power consumption

required is low.

Back-up power supply: TV channel storage - typically 1

year, Clock/Timer - typically 30 hours.

This manual is related to the following products: