Programming with 'videopius, Important notes for programmed recordings, Programming with'videopius – Philips 20PV 184 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Programming with 'VIDEOPIus+'
All the information required for programming is encoded in
the'VIDEOPIUS+'code.
^ Press the I | button on the remote control.
o Enter the entire 'VIDEOPIus+ code'. This code (up to 9
digits) is found next to the start time of a TV programme
in your TV guide.
If you entered an incorrect code number, clear it with
the I.
clear
I button.
VIDEOPLUS
" S
CODE
DAILY/WEEKLY
ONCE
PROGRAMME HR.
0 1
0-9
OK
V
o If you want to repeat programming at daily or weekly
intervals, select the required setting in the 'DAILYAA/EEK-
LY' line.
'Daily' programming can only be used for recordings to
be made from Mondays to Fridays inclusive.
Q After the confirmation the corresponding data appears
on the TV screen.
Note: If you use 'VIDEOPIusV for the first time, the
'PROGRAMME NR.' line appears when you enter the
'VIDEOPIUS+' code. Enter the required programme num
ber for this TV channel.
DATE DW PR START EHD
01
01 17:15 18:45
**
0-9
OK
^ Confirm with the I ok I button.
The data has been stored in a TIMER block.
Please ensure that you loaded a cassette without erase
protection.
How to enter, check or clear a TIMER
block manually
^ Press the I
timer
0 | button.
Q Select a free TIMER block or the TIMER block you want
to check or clear.
^ Clear: Press the I
clear
| hiittnn.
Q
Enter/Check: Press the L.~^_l or I ► I button to switch
between 'DATE' (date), 'DW' (daily, weekly), 'PR' (pro
gramme number), 'START' (starttime) and 'END' (end
time). ________ ___________ ___________
Press the I
^
I and the I ▼ I, or the I Q-9 I buttons to
change the data.
o To end programming, press the I I button.
^ Press the I
standby
dJl button.
Important notes for programmed recordings
• If
the message 'PLEASE PRESS STOP' or 'PLEASE PRESS
STANDBY'
appears on the TV screen, press the
I
STOP» I or the I STANDBYO I button.
^ Press the I
standby
(IT] button.
A TIMER recording will function only, if the set isn't used
for other video recorder functions (e.g.: playback).
The TIMER lamp on the front of the set lights up when
one or more of the TIMER blocks are occupied.
If the end of the cassette is reached during a recording,
the video recorder automatically ejects the cassette. The
set switches off after a few minutes.
If you forget to load a cassette, 'NO CASSETTE CANNOT
RECORD' will appear.
If you inserted a cassette with erase protection when
you want to start a recording, the cassette will be
ejected.
If 'CODE ERROR' appears on the TV screen, you entered
an incorrect code number or the incorrect date. Repeat
the entry or end with the I
standby
551 button.
With 'Daily' programming, the first recording must take
place within a week.
If 'DAILY ERROR' appears on the TV screen, the date was
incorrectly entered.'Daily' programming can only be
used for recordings to be made from Mondays to Fridays
inclusive.
The programmed recording will always be made at the
recording speed (SP/LP) that has already been selected
on the TV Combi.