Philips AZ 7583 - Manual (Page 11)

CONNECTIONS
Connections for in-car use {supplied or optionally available!
AY 3545 - car voltage converter (4.5 V/600 mA, DC, positive pole to the center pin),
AY 3501 - car adapter cassette.
1 Find a safe place for the
CD player on a horizontal,
vibration-free, stable
surface where it is no
danger to or in the way of
the driver or passengers.
2 Connect the DC plug of the
voltage converter to the DC
socket of your CD player
{only for a 12 V car battery, negative grounding).
3 Plug the voltage converter into the cigarette lighter socket. If necessary, clean the
cigarette lighter socket to obtain a good electrical contact.
4 Turn down the volume and switch off the auto-reverse function of your car
radio's cassette player.
5 Connect the adapter cassette plug to the О LINE OUT socket of the CD player.
6 Insert the adapter cassette carefully into the car radio's cassette compartment.
7 Make sure that the cord does not hinder your driving.
8 Start the CD player, set its volume to position 8, and adjust the sound with the car
radio controls.
To remove the adapter cassette, press the eject button of the car radio's cassette
player.
Always remove the voltage converter from the cigarette lighter socket when the CD
player is not in use.
Notes on in-car use:
- Avoid excessive heat from the car heater or from direct sunlight (e.g., in a parked car
in the summer!.
- if your car radio has a LINE IN jack, it is best to use it for the car radio connection
instead of the adapter cassette. Connect the signal lead to this LINE IN jack and to
the ÍÍ LINE OUT jack of the CD player.
11