Philips G480 - Manual (Page 9)

Shaving With Mini Shaver
Attachment
Use the narrow mini shaver to shave along con­
toured edges to remove any stubble while creating
a smooth, well-defined beard line.
I Before using the mini shaver, always check it
for wear and damage. If the mini shaver shows
signs of wear or damage, do not use it as injury
may occur. Do not use the mini shaver until it
has been replaced.
II
Pre-trim the contours desired with the
full size trimmer or precision trimmer
without a comb attachment.
a
Put the mini shaver attachment on the
Groomer (fig. 24).
Q Gently press the mini shaver onto the skin
and shave along contoured edges to remove
any stubble. Do not press too hard.
Hair Clipping
k Make sure that the appliance is fully charged
before you start clipping hair. The appliance
will not operate while cord is connected to
electrical outlet.
I Before you start clipping, make sure that the
head of the person whose hair you are cutting
is at the same level as your chest so that all
parts of his/her head are clearly visible and
within easy reach.
I Only use the appliance on dry hair,
k Do not use on freshly washed hair.
k Before you begin,comb the hair in the direction
of growth (fig. 25).
k To achieve optimal clipping results, always move
the appliance slowly through the hair against
the direction of hair growth.
Clipping with hair comb attachment
II
Put the full size trimmer attachment on
Groomer (fig. 3).
u
Slide the hair clipper comb into the guiding
grooves on both sides of Groomer and push
until you hear it ‘click’ into place (fig. 26).
Q Press the Hair Length Selector and slide it to
the desired setting (fig. 27). See Table 3 for
settings.
Q The setting selected will appear on the back
of the Groomer (fig. 6).
When you are clipping for the first time, start
at the maximum clipping length setting (#9)
to familiarize yourself with the appliance and
prevent accidentally trimming hairs too short. As
you become familiar with the settings, adjust the
Hair Length Selector to desired trimming length.
Selector will 'click' into position at each setting.