Philips G480 - Manual (Page 6)

Beard Trimming Without
Beard & Moustache Comb
Remove comb if you are:
k Defining hair lines
I Trimming nape of neck
I Removing single, unwanted hairs
II
Be certain the Groomer is in the OFF
position.
H Remove the comb attachment by pressing
and sliding the Hair Length Selector upwards
(fig-9).
Never pull off the comb attachment by grasping
the flexible top portion. Always pull off by the
bottom part of attachment.
u
Switch the Groomer ON.
□ Make well-controlled movements. Touch the
hair/skin lightly with the Groomer.
Defining Beard, Moustache and
Sideburns With Precision
Trimmer Comb
II
Be certain the Groomer is in the OFF position.
H Remove the comb attachment by pressing
and sliding the Hair Length Selector upwards
(fig-9).
□ Remove the full size trimmer by pulling it off
the handle (fig. 10).
Q Put the precision trimmer attachment on the
Groomer (fig. 11). You will hear a click.
B Slide the precision comb into the guiding
grooves on both sides of the Groomer and
push until it‘clicks’ into place (fig. 12).
Q Press the Hair Length Selector and slide it
to the desired trimming length setting
(fig. 13).The selected setting number will
appear on the back of the Groomer (fig. 6).
See Table 2 for settings.
I If you are trimming for the first time, start by
using the comb at the maximum trimming
length setting (#4) to prevent accidentally
trimming hairs too short.
► Hold the Groomer upright when you use the
precision trimmer attachment.
I REMEMBER:You must reset the hair length
selector back to your desired setting every
time you replace the comb on the appliance.
Table 2. Precision Trimmer
Setting Remaining hair length
(in.) /(mm)
1
Stubble .08 in/2mm
Closely Cropped . 16 in/4mm
3 Short .24 in/6mm
Medium Short .31 in/8mm