Philips G480 - Manual (Page 5)

Trimming
I Use this Groomer for ics intended household
use as described in this manual.
I Make sure that the Groomer is full/ charged
before you start trimming. This Groomer will
not operate while cord is connected to
electrical outlet.
I Make sure hair is clean and dry.
I Always comb the hair with a styling comb in
the direction of growth before you start
trimming.
Do not move the Gto
and genUe movements.
Trimming your Beard & Moustache
with Beard & Moustache Comb
Attachment
a
Put the full size trimmer attachment on
Groomer (fig. 3).You will hear a click.
Q Slide the beard & moustache comb into
the guiding grooves on both sides of the
Groomer and push until it 'clicks' into place
(fig-4).
Q Press the Hair Length Selector and slide it
to the desired trimming length setting (fig. 5).
The selected setting number will appear on
the back of the Groomer (fig. 6). See Table 1
for settings.
I If you are trimming for the first time, start
by using the comb at the nuximum trimming
length setting (#9) to prevent accidentally
trimming hairs too short. As you become
familiar with the settings, adjust Hair Length
Selector to desired trimming length. Selector
will "click" into position at each setting.
О
Switch the Groomer ON.
Q To trim in the most effective way. move
the Groomer against the direction of hair
growth. Make sure the surface of the comb
always stays in contact with the skin (fig. 7).
NOTE: Since .ill haifs do not ^row in the same
direction, you may want to try different trimming
directions fi.e, upwards, downwards, or across!.
Practice is for optimum resuit&
Ufa lot of hair has accumulated in the comb,
remove the comb and blow and/or shake the
hair out of the comb. You can also use the
cleaning brush provided to remove
hair from the comb area.
Table 1. Beard Trimmer
Setting
I StutOte
Remaining hair length
(In.)/(mm)
.06 m/Tmm
Oose^ Cropped
Short
Medum Short
Medum
16 ifV4mm
i4 in/6mm
.31 in/8rtvn
.39 fft/IOmm
Medum Long
Lor^
■47n/l2mm
55 rt/l4mm
6 ExtraLong .63 «VI6nvn
9 Longest 71 «Vl6nvn
I REMEMBER:You must reset the hair length
selector back to your desired setting every time
you replace the comb on the appliance
I The remaining hair length corresponds with
the smallest distance between the cutting
blade and the spot where the comb is in contact
with the skin.
I Setting the comb to #1 position will result in a
stubble beard look (fig. 8).