Philips G480 - Manual (Page 7)

Defining Beard, Moustache and
Sideburns Without Precision
Trimmer Comb
Remove comb if you are:
I Shaping moustache and sideburns
► Defining contours
I Removing single, unwanted hairs
D Be certain the Groomer is in the OFF
position.
a
Remove precision comb attachment by press­
ing and sliding Hair Length Selector upwards
(fig. 14).
□ Switch the Groomer ON.
Q Hold the Groomer upright and trim the
desired areas (fig. 15).
Using Nose/Ear HairTrimmer
D Be certain the Groomer is in the OFF
position.
a
Remove the full size trimmer attachment by
pulling it off the handle (fig. 10).
u
Put the nose/ear hair trimmer attachment on
the Groomer (fig. 16).You will hear a click.
Trimming Nose Hair
> Make sure nasal passages are clean.
H Place nose/ear hair trimmer attachment
on Groomer (fig. 16).
u
Switch the Groomer ON and insert the tip
of the attachment into one nostril (fig. 17).
CAUTION: Do Not insert the tip more
than 3/16 in./5mm into your nostril.
Q Slowly move the tip in and out while
turning it around at the same time in order
to remove unwanted hair. For best results,
make sure the side of the tip is firm against
skin.This will reduce the tickling effect that
can occur during trimming of nose hair.
□ Turn off Groomer. Rinse attachment clean
after each use.
Trimming Ear Hair
► Clean outer area of ear and ear canal. Make
sure it is free of wax.
I Nose/ear hair trimmer attachment should be
on the Groomer.
D Switch the Groomer ON and move the tip
softly around the edge of ear to remove hairs
extending beyond the outer ear (fig. 18).
B Carefully insert the tip into outer ear canal
(fig. 19).
CAUTION; Do not insert the tip further
than 3/16 in./5mm into the ear as this
could cause damage to the eardrum.
B Turn off Groomer. Rinse attachment clean
after each use.