Futaba CDR-5000 Charger - Manual (Page 7)

8
Bef
o
re
Using
Set Contents/Nomenclature
Please check the contents of your shipment comparing to the parts shown here.
If you believe that you are missing any of these parts, please contact the distributor from whom you
purchased the system.
CDR-5000
•"TX/RX Charging"
LED
•"TX/RX Discharging"
LED
•LCD display
•Heat sink protector
•"DX Charging" LED
•"DX Discharging" LED
•Edit keys
Accessories
•TX charge adaptor
*This is used for charging/discharging batteries for
transmitters. Please make sure that polarity is correct
before connecting the adaptor to TX/TR terminal of CDR-
5000.
•RX charge adaptor
*This is used for charging/discharging batteries for
receivers. Please make sure that polarity is correct before
connecting the adaptor to TX/TR terminal of CDR-5000.
•Terminal harness
*This is used for measuring characteristics of each cell in a
serially composed battery (2 - 6 cells). Connect the other
end of a terminal harness to the "Terminal Harness" on
CDR-5000.
•Conversion table sheet between Celsius
and Fahrenheit temperatures