Compaq V5100 - Manual (Page 106)

5–16 Maintenance and Service Guide
Removal and Replacement Procedures
✎
Before disconnecting the antenna cables, make note of which
cable is attached to which antenna clip on the Mini Card
communications card.
3. Disconnect the auxiliary and main 1 antenna cables from the
Mini Card communications module.
4. Slide the retaining bar 2 forward. (The edge of the module
opposite the socket rises away from the computer.)
5. Remove the Mini Card communications module by pulling
the module away from the socket at an angle 3.
✎
Mini Card communications modules are designed with
notches 4 to prevent incorrect installation into the Mini Card
module socket.
Removing a Mini Card Communications Module
Reverse the above procedure to install a Mini Card
communications module.