Futaba 8JN - Manual (Page 7)

Throttle button trimmer
THROT The throttle servo is operated at
the position set by this trimmer by push-
ing the throttle button.
The total travel can be set at throttle stick
neutral position.
Roll A button trimmer 1 ROLL (A)
Roll B button trimmer 1 ROLL (B)
This trimmer sets the aileron travel when the
roll button is pushed.
The travel is variable over the entire travel
range at aileron stick neutral.
Snap roll A button aileron trimmer
SNAP ROLL (A) 1 AIL
Snap roll B button aileron trimmer
SNAP ROLL (B) 1 AIL
These trimmers set the aileron travel when the
snap roll button is pushed.
The travel can be varied over the entire travel
range.
Snap roll A button elevator trimmer
SNAP R O L L ( A ) 2 ELEV
Snap roll B button elevator trimmer
SNAP ROLL(B-> 2 ELEV
This trimmer sets the elevator travel in the
same manner as trimmers and
Snap roll A button rudder trimmer
SNAP R O L L ( A ) RUD
Snap roll B button rudder trimmer
SNAP ROLL (B) RUD
These trimmers set the rudder travel in the
same manner as trimmer and
Elevator, flap MIX trimmer
MIX ELEV-> FLAP
This trimmer adjusts the amount of mixing
from the elevator to the flap.
The travel can be varied over the entire travel
range at flap channel neutral.
Spoiler (channel 7), flap (channel 6) MIX
trimmer
MIX SPOIL-> FLAP
This trimmer adjusts the amount of mixing
from the spoiler to the flap.
Travel range is the same as that of trimmer
Elevator dual trimmer
ELEV. DUAL
This trimmer adjusts the travel at elevator dual
rate ON.
The travel is continuously variable from 40%
to 100% of the total travel range.
Channel 6 flap neutral trimmer
MIX NEUTRAL
Elevator ATV U trimmer
ELEV. ATV-U
This trimmer adjusts the elevator travel in the
UP direction when the elevator reverse switch
is in the NORM position. Adjustment range
is the same as that of the aileron ATV
Elevator ATV D trimmer
ELEV. ATV-D
This trimmer adjusts the elevator travel in the
DOWN direction when the elevator reverse
switch is in the NORM position. Adjustment
range is the same as that of the aileron ATV
Rudder ATV R trimmer
RUD. ATV-R
This trimmer adjusts the rudder travel in the
right direction when the rudder reverse switch
is in the NORM position. Adjustment range is
the same as that of aileron ATV
Rudder ATV L trimmer
RUD. ATV-L
This trimmer adjusts the rudder travel in
left direction when the rudder reverse switch
is in the NORM position. Adjustment range is
the same as that of aileron ATV
Transmitter module
The frequency, frequency band and modula-
tion method can be changed by changing this
module. The method of changing this module
is shown in Fig. 12.
Trimmer panel
This panel is removed by sliding it in the di-
rection of the OPEN arrow.
This trimmer sets flap neutral at spoiler (chan-
nel 7) and flap (channel 6) mixing.
Neutral adjustment is possible in all spoiler
states.