Futaba 7C 2.4GHz - Manual (Page 76)

v Speed switching and governor ON/OFF may be used together on one switch.
v Speed setting control uses CH7.
The GV-1 controls throttle when it is active, so the throttle will not obey any FailSafe settings preset for throttle in
the transmitter. Always set the FailSafe setting for the GV-1’s on/off channel to OFF. This way the governor is shut
off and the throttle obeys the FailSafe throttle commands.
Setting example: When speed and ON/OFF are using one switch:
v
v
from +LIMIT to -LIMIT or vice versa.
Expert Tip: Mounting the GV-1 to the counter gear instead of the fan
dramatically simplifies installation in many models.
76
Governor Speed
RS1: OFF
RS2: 1400
RS3: 1700
Switch Position
(Switch B or E)
Up or NORM
CNTR or IDL1
DOWN or IDL2
Rate (%)
0
50
100
Adjustment from Tx.
Use up to 0%. (Governor
speed display reads “off”.)
Speed adjusted by raising
and lowering rate.
Speed adjusted by
lowering rate.
Adjustability: