Futaba 7C 2.4GHz - Manual (Page 43)

FLAP-TRIM allows the flap action to be set in a way that it can be adjusted with the VR
dial. AIRBRAKE will also move the flaps to a specified position via movement of a switch.
The flaps can also be moved with switch using a programmable mix. See offset as master
p.53.
43
Add FLAP-TRIM to allow the model's
ailerons to drop 30% together as flaps
from the VR dial.
The FLAPERON function must be
active with the second servo set to CH6.
*If the FLAP-TRIM is inhibited the flap control defaults to the VR dial. You can use E.POINT to set the travel of the flap if you are using one flap servo.
If you are using flaperons with CH1 and CH6 DO NOT inhibit FLAP-TRIM.
Open FLAP-TRIM.
Set the dial to desired zero flap side.
Set the dial to desired full flap side.
Set flap throw (Ex 30%).
Set the OFS so that the flap will work
for the full range of the dial.
Close menu.
for 1 second.
(If basic, again.)
to
to 30%.
full left.
full right.
FLAP-TRIM.
The function is automatically activated with the FLAPERON.