Futaba 3PL 2.4GHz FHSS - Manual (Page 16)

16 3PL-2.4G Functions
3PL-2.4G Functions
Steering Trim (TRM-CH1)
B25 - 0 - F25
Throttle Trim Throttle neutral adjustments can be made moving the throttle trim to the
left or right.
Racers Tip
When using an electronic speed control, set the throttle trim to neutral
and make adjustments to the speed control. On a gas powered model, set
the trim to neutral and adjust the linkage to the point where the carburetor
is fully closed in accordance with the engine instruction manual.
Trim Operation and Travel
Trim adjustments will affect the overall servo travel. Check the brake
side (backward) movement when changes are made.
When trim movement is extreme
If you use most of the trim movement to get the servo to the neutral
position, recenter the servo horn closer to the neutral position and
inspect your throttle linkage.
Throttle Trim (TRM-CH2)
L25 - 0 - R25
Steering Trim Steering neutral adjustments can be made by moving the Steering trim
knob to the left or right.
Racers Tip
When you install a servo, always check to be sure the servo is at its neutral
position. Adjust the servo horn hole position and linkage so both are parallel.
When a servo saver is used, place it as close to center position as possible. Be
sure the steering trim on the transmitter is at the neutral position.
90 90
Parallel
Servo Saver
Direct Servo Saver Horn
Trim Operation And Maximum Travel
Changing the trim can affect the overall settings. When
adjustments are made with the trims, recheck your installation
for maximum travel. (Steering EPA right side and left side).
When Trim usage is extreme
If it takes most of your trim movement to get a servo to the neutral position, reposition
the servo horn or servo saver on the servo and inspect your linkage installation.
(Drum Type)
(Slide Type)
Carburetor Fully Closed
Steering Dual Rates (D/R-CH1)
Use this function to adjust the steering travel of your model. If the
model understeers (push) while cornering, add steering by pressing the
upper side of the D/R button. When the model oversteers (loose), take
away steering by pressing the lower side of the D/R button.
• This function can not be used when 4WS mixing is activated.
30 - 100%
Steering D/R