Futaba 2NBR - Manual (Page 5)

•THROTTLE STICK NEUTRAL LEVER OPERATION
•The neutral position of the throttle stick (engine control stick) at the left side can be selected in two stages by moving
the neutral lever as shown in the figure.
When neutral
lever up
When neutral
lever down
If the neutral lever is moved, the
neutral position of the stick
lever can be adjusted in two
steps as shown in the figure.
When the neutral lever is up, the
throttle stick can be adjusted to
a total of 54°, 27" up and 27°
down, from the neutral posi-
tion. This position is best for
electric cars and other models
with which the center of the
speed controller is the neutral
position. When the neutral lever is down,
the throttle stick can be ad-
justed to a total of 54°, 36° up
and 18° down (2-to-1), from the
neutral position. This position is
best for engine-drive cars or
other models with which the
speed controller neutral position
is offset.
•CHANGING THE THROTTLE STICK FROM A
SELF NEUTRAL SYSTEM TO A RATCHET
SYSTEM
•When changing the throttle stick from a self-neutral
system to a ratchet system, install the optional slider.
Then, remove the spring and swing arm.
Twist with long-nose
pliers.
Remove the
spring and
swing arm.
Install the optional
slider.
•CRYSTAL REPLACEMENT
•When changing the band, remove the crystal holder and
change the crystal. (Except 72. 75MHZ)
•Futaba Digital Proportional Frequencies (FOR
U.S.A.)
• The frequency of Futaba digital proportional sets can be
changed among bands (1) ~ (6) on the 27MHz band only.
• However, a 27MHz band set cannot be changed to 72MHz
band, and vice versa.
• Therefore, always, attach the correct frequency flag to
the end of the transmitter antenna. Each frequency band
has its own designated color, as stated above. The fre-
quency flag is intended for identification purposes.
• Also change the frequency flag when frequency is
changed.
• Futaba paired crystals are precisely matched. Always use
a Futaba crystal set (transmitter, receiver) when changing
the frequency.
• It is illegal to change crystals of transmitter on the 72-75
MHz bands in the U.S.A.
Frequency Channel No. Flag Color
•SWIVEL STICK SETTING
• To adjust the operating direction of the stick lever, loosen
the four screws shown in the figure and turn the stick
body and set it to the best position. After setting the
stick, retighten the four screws.
(1) Loosen these four screws.
(3) Tighten these four
screws.
(2) Select the angle by
turning the stick body.
Stick lever can be set
within this range.
5°. 5°
4