Futaba 2NBR - Manual (Page 11)

•IF ASP OPERATES
• If ASP system operates and the vehicle stops. Set to OFF once
set the transmitter power switch to OFF
once and set it to ON again. Then ASP system
stops working and you can start again.
• Restart running time depends on the variety
and condition of vehicle, motor, and battery.
Be careful about that.
ON
OFF
Set to ON again.
•WHEN VEHICLE WILL NOT BE USED
Be sure and release the connector of running
Nicd battery except when you are on the way
to the starting line.
When not using the
connector, set the
switch to OFF.
Release the connector.
FP-S128
No.
1.
2
3.
4.
5.
6.
7.
8.
9.
10
11.
12.
13.
14.
15.
16
17.
18.
19.
20.
21.
22.
Part Name
Upper case
Middle case
Bottom case
Metal bearing
Potentiometer
VR drive plate
Motor
Motor pinion
Motor mounting
screw 2 x 3
1st gear
2nd gear
3rd gear
Final gear
Intermediate shaft
2nd shaft
Servo horn D
Horn mounting screw
2 . 6 x 8
Printed wiring board
S128...3PBWRB300
Lead wire packing
Case mounting screw
Nameplate
Part No.
FCS28
S04134
139995
S02753
S91212
S02461
J 50002
FGS-28
S02495
S02494
FSH-6W
FSH-41
AS1202
FPC-8M
S90045
J50400
S80700
The following splined horns are optional.
HORN A HORN B HORNC HORN D HORN E HORN F
•SPLINED HORNS
This horn permits shifting of the
servo neutral position at the servo
horn. Setting and shifting the neutral
position
a) Angle divisions
1) The splined horn has 25 seg-
ments. The amount of change per
segment is; 360-25=14.4°
2) The minimum adjustable angle is
determined by the number of arms or
number of the holes. For four arms,
the minimum adjustable angle is:
b) Effect
To shift the holes center line to the
right (clockwise) relative to baseline
A, shift arm 2 to the position of arm
1 and set it to the position closet to
baseline A.
[Example] For a four arm horn, the
angular shift per segment is 14.4°.
The shift to the right is 90° - (14.4 /
6) = 3.6°
To shift by the same angle in the
opposite direction, use the opposite
arm number.
For a six arm horn, turn the arm
counterclockwise and set arm 2 to
the position of arm 1. The adjustable
angle is 60° - (14.4 x 4) = 2.4°.
Arm 3 shift 4.8° to the right, arm 6
shifts 2.4° to the left, and arm 4
shifts 7.2° to the right and left.
10