Futaba 2NBR - Manual (Page 10)

•STARTING
When the ASP operates and the vehicle
stops as soon as it starts to run, there is
trouble somewhere.
•Since the vehicle, running Nicd battery,
motor, etc. is abnormal when ASP was
operated, check again.
•IF ASP OPERATES
(Vehicle trouble)
•If something gets caught in the gears or the
tires do not rotate smoothly and an over-
current flows in the motor, ASP may operate.
When using the common power supply diode
and regulator with a vehicle without BEC spe-
cifications. release ASP. Otherwise, ASP will
operate immediately.
•Since the Futaba and FP-R102GF receivers
have the BEC system built into them,
a diode and regulator are not connected.
(Running Nicd battery trouble)
•When the Nicd battery is charged insuffici-
ently or is old, ASP will operate.
Insufficient charge
Capacity of used
Nicd is low.
(Motor trouble)
•When a modified motor, high power motor,
or a motor whose angle cannot be adjusted
is used and when the motor is accelerated and
reversed suddenly, ASP may operate.
•When using high power motor, set ASP to
OFF with ASP release connector. But when
setting ASP to OFF, be careful that the ve-
hicle may run away if the capacity of run-
ning Nicd battery runs short.
R102GF ASP
release
connector
Insert the ASP release connector
packed with the set at this 2P
connector (male pins) on the
printed wiring board.
9