Flyzone HCAA42 User Manual
Page 5
5
ASSEMBLE THE MODEL
Mount the Main Landing Gear
❏
1. Place the fuselage upside-down on your workbench.
Remove the landing gear cover (shown below) from the
bottom of the fuselage. Fasten the main landing gear with
the two, larger (3mm) Phillips screws included with this kit
and a Phillips screwdriver (a #2 works best, but a #1 Phillips
screwdriver is also suitable).
❏
2. Remove the protective strip from the double-sided tape
on the inside of the landing gear cover. Stick the landing gear
cover into the fuselage over the landing gear.
Mount the Vertical and Horizontal
Stabilizers (Fin and Stab)
❏
1. Key the post coming out of the bottom of the vertical
stabilizer (fi n) into the hole in the plastic plate on the top
of the horizontal stabilizer (stab) and join the two for a
tight fi t.
❏
2. Slide the wire elevator and rudder pushrods out of the
back of the fuselage—the pushrods are identical to each
other, so don’t worry about keeping track of which is which.
Connect the “Z” bend on the end of the pushrod wires to the
holes in the control horns for the rudder and elevator—note
that there are two holes in the elevator horn—the pushrod
goes into the outer, or bottom hole.