Flyzone HCAA1981 - Manual (Page 4)

❏
1. Apply the decals to the top of the airplane surfaces
as seen on the box. (The top of the V-tail has the two screw
heads showing.)
❏
2. Insert the mounting bolts of the V-tail through the
holes from the top of the tail boom as shown in the photo.
❏
3. Install the tail skid over the mounting bolts. Make sure
the tail skid is pointing down and to the rear of the airplane.
❏
4. Place the two nuts on the mounting bolts that
extend through the bottom of the tail boom as shown in
the photo. Using the included wrench, tighten the nuts
firmly but do not overtighten. You have now completed
the assembly of the V-tail.
❏
5. Spread the metal clevises apart and insert the
clevis pin in the outer hole of the control horns. Make
sure the clevis snaps closed over the control horn.
❏
1. Position the wing, centered on the fuselage. The
two indentations on the top of the wing should be
aligned with the center of the fuselage. Secure the wing
with two rubberbands.
INSTALL THE WING
INSTALL THE V-TAIL
4